Tea Machineries - Double Action Open Top Roller
|
|
General Usage
Double Action Roller Machine is used for rolling and cutting the withered tea
leaves, for the purpose of obtaining well produced tea powder while the machine
keep rolling. The roller table rotates while the cylinder that carries the tealeaves
rotates the other way.
Technical Data and Construction
- Cylinder part is made of Stainless steel thickness 2.5 mm, strengthen with stainless steel flat bars with thickness 8 mm on the upper and lower parts.
- Cylinder frame is made of Cast Iron, rotated by 3 units of big and strong crankshafts.
- Roller table is made of cast iron
- The edge of the table is made higher, this is to avoid the overflow of the tealeaves, that is not well withered, in the grinding process. The height of the table edge is 8 cm.
- The table surface is lined with Stainless steel plate of thickness 1.5 mm and made slanted inward, so that the tealeaves are curled more.
- The table equipped with 8 units of crescent-shaped “Batten” gunmetal to increase the percentage of tea powder obtained.
- The discharging door is placed in the center of the table; on top of it, “Retie Cone” is installed. The Retie Cone is made of gunmetal, this is to ensure the better quality of the tealeaves in the cylinder; having rolled and cut evenly.
- The door opening system uses sliding shaft concept is placed in the front part of the machine for easy operation.
- A pair of gear “Worm Wheel” is installed with the main crankshaft and assembled on the oiled gearbox.
- 3-roller support made of cast iron assembled on a cast iron frame.
Technical Specification
- Cylinder Diameter : 1183 mm
- Capacity : 300 – 350 kg/process
- Shaft capacity : 42 – 45 rpm (as requested)
- Electromotor : 20 HP, 1440 rpm, 50 Hz, 380/660, Squirrel cage and TEFC
- Worm wheel : type 09 Ratio 1 : 20
Other Information
- Minimum area needed
- Length : 2625 mm
- Width : 2210 mm
- Height : 1962 mm
Click Here to Request for More Information
|
